FIRSTLY YOU'LL NEED A TANK OR VIVARIUM, THEN A UV BULB(5.0 UVB IS BEST), THEN YOU'LL NEED A BASKING LAMP(2 IF YOU HAVE A V. LARGE VIVARIUM), A DIMMER SWITCH FOR THE BASKING LAMPS, A STARTER UNIT FOR THE UV BULB, A HEAT MAT, A THERMOSTAT TO TURN YOUR HEAT MAT ON/OFF WHEN NEEDED, SOME SUBSTRATE, & A WATER DISH. OH AND DONT FORGET YOU'LL NEED AN OVEREXPENSIVE SPRAY TO KEEP YOUR LIZARDS SKIN CORRECT.
ASSEMBLY INSTRUCTIONS
TAKE YOUR VIVARIUM/TANK AND FIX YOUR UV BULB INTO IT SOMEHOW, THEN TAKE YOUR STARTER UNIT AND PLUG IT INTO YOUR BULB, NOW FIX A BASKING LAMP ON TO YOUR VIVARIUM/TANK AND CUT THE WIRE HALF WAY, NOW JOIN THE NEUTRAL WIRES BACK TOGETHER AND PUT EACH LIVE WIRE IN TO THE DIMMER SWITCH, AND FIX THE SWITCH TO SOMETHING, NOW TAKE YOUR HEAT MAT AND CUT OFF THE PLUG, PUT THE PLUG END ON TO YOUR THERMOSTAT WHERE IT SAYS HEAT, THEN PUT YOUR SENSOR FROM YOUR STAT IN YOUR TANK/VIVARIUM, THEN PUT THE MAINS PLUG IN TO THE SOCKET, PLACE YOUR SUBSTRATE ON THE FLOOR OF YOUR TANK/VIVARIUM COVERING UP YOUR HEAT MAT ( NO MORE THAN 1 cm OF SUBSTRATE OVER THE MAT) AND SWITCH IT ALL ON, PLACE YOUR WATER DISH SOMEWHERE AROUND AND THAT'S IT.
OBVIOUSLY YOU SHOULD FOLLOW MANUFACTURERS INSTRUCTIONS THAT COME WITH PRODUCTS IF THE ABOVE INSTRUCTIONS DONT SEEM TO 'ADD UP' WITH YOUR EQUIPMENT.